Showcase
Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Medicine organizer with lid
MAIN PURPOSE: Store medicines and plasters under a lid
Six compartments for medicines and plasters with a telescoping lid and MEDS on the front.
Printing notes
257.1 cm³
Volume
318.8 g
Est. weight
3,524
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Vitamin bottle turntable
MAIN PURPOSE: Spin vitamin and medicine bottles into view
A round tray on a Lazy Susan base that spins vitamins and medicine bottles into view.
Printing notes
289.2 cm³
Volume
358.6 g
Est. weight
6,072
Triangles
Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Weekly pill organizer
MAIN PURPOSE: Sort pills by day of the week
Seven compartments, one for each day, with a press-on lid.
Printing notes
110.7 cm³
Volume
137.3 g
Est. weight
7,044
Triangles
Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
Contact lens travel case
MAIN PURPOSE: Carry contact lenses while travelling
A small capsule case in two halves with a press-on lid.
Printing notes
27.7 cm³
Volume
34.4 g
Est. weight
2,680
Triangles
Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.