Showcase
Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Gongfu tea tray
MAIN PURPOSE: Brew tea with a drainage tray
A tea tray for brewing at the table: pour freely and the water runs through the slatted top into the hidden reservoir below.
Printing notes
194.9 cm³
Volume
241.6 g
Est. weight
7,580
Triangles
Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Tasting flight board
MAIN PURPOSE: Serve a flight of tasting glasses
A board with four linked rounds for the feet of tasting glasses, numbered along the front, for wine, beer or whisky flights.
Printing notes
94.8 cm³
Volume
117.6 g
Est. weight
7,308
Triangles
Prints as shown on its floor, no supports.
Sprouting jar lid
MAIN PURPOSE: Sprout seeds in a wide-mouth jar
A perforated cover for a wide-mouth jar: rinse the seeds, turn the jar upside down and the water drains through the mesh while the sprouts stay in. Print it as shown, then turn it over so the floor becomes the top.
Printing notes
17.0 cm³
Volume
21.1 g
Est. weight
7,024
Triangles
Print floor-down as shown, then turn it over to use it.
Coffee pod and sugar station
MAIN PURPOSE: Hold pods, sugar and a stirrer cup
A three-bay coffee station for pods, sugar sticks and stirrers, with a tall stirrer cup on the side and COFFEE raised on the front.
Printing notes
166.4 cm³
Volume
206.4 g
Est. weight
5,988
Triangles
Prints as shown on its floor, no supports.
Espresso capsule drawers
MAIN PURPOSE: Hide espresso capsules in drawers
Two bar-handled drawers that keep espresso capsules flat and hidden under the coffee machine.
Printing notes
337.7 cm³
Volume
418.8 g
Est. weight
1,064
Triangles
Prints as shown on its floor, no supports. The 2 drawers print separately from the case.
Coffee carousel with centre hub
MAIN PURPOSE: Spin coffee pods and sachets around
An eight-section coffee carousel with a solid centre hub that spins on BBs, for pods, sachets and spoons.
Printing notes
557.8 cm³
Volume
691.7 g
Est. weight
6,944
Triangles
Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Two-tier coffee bar organizer
MAIN PURPOSE: Stack pods, sugar and stirrers in tiers
A coffee bar organizer with a second tier stacked on a rim fit, so pods sit below and sugar and stirrers on top.
Printing notes
206.9 cm³
Volume
256.5 g
Est. weight
4,372
Triangles
Prints as shown on its floor, no supports. Stacked parts are fused into one print.