Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print many in one colour or a gradient; 15 mm split rings. Prints flat as a plate, no supports.
Print flat in PLA; press or glue an M8 nut into each pad.
Print upright; drop a bag of sand into the base for weight. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print flat; print 100 %, 75 % and 55 % widths for three tiers.
Two 4 mm rods 260 mm long; twenty 20 mm wooden beads. Prints as shown on its floor, no supports.
Glue 16 x 6 x 3 mm magnets flush, polarity as described. Prints as shown on its floor, no supports.
Print floor down; the floor becomes the back. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print 24 flat in PETG; 36 M3 screws and nylock nuts. Prints flat as a plate, no supports.
Print twelve flat; two M3 bolts. LED lights only. Prints flat as a plate, no supports.
Print four flat in PETG; M4 bolts, nylock nuts, a pencil. Prints flat as a plate, no supports.