Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print open end up, then stand it on its open end. Print floor-down as shown, then turn it over to use it.
Print upright. Holds a portrait postcard (105 x 148). Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print two in contrasting colours with different names. Prints flat as a plate, no supports.
Print lying flat; stand it on the baseline.
Print in silk or marble PLA at 100 % infill so it has weight. Prints as shown on its floor, no supports.
Print in black; fill with cork or putty. 6 x 2 mm magnet. Prints as shown on its outline, no supports.
Print lying on its profile; all parts come out solid. Prints as shown on its outline, no supports.
Print open side up, glue in a coin, then flip. Print floor-down as shown, then turn it over to use it.
Print a few; PETG keeps the tines straight. Prints flat as a plate, no supports.
Print as it comes (profile on the bed) in PETG or ASA; radiators reach 70 C.