Showcase
Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Handlebar end plugs
MAIN PURPOSE: Close open handlebar ends
Push-in end caps for 22 mm bicycle handlebars, replacing lost originals: an open bar end can cut like a punch in a fall.
Printing notes
4.0 cm³
Volume
5.0 g
Est. weight
1,360
Triangles
Print two in PETG or TPU. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
MAIN PURPOSE: Keep glasses handy in the car
Clips onto a car sun visor and holds sunglasses or reading glasses by one arm, always within reach and never sliding about on the dashboard.
Printing notes
10.1 cm³
Volume
12.5 g
Est. weight
568
Triangles
Print lying flat in PETG or ASA.
Windscreen ice scraper
MAIN PURPOSE: Scrape ice off car windscreens
A flat ice scraper with a wide blade for windscreens and a long, narrow handle that keeps your knuckles off the glass; print it in PETG so it stays tough in the cold.
Printing notes
42.4 cm³
Volume
52.6 g
Est. weight
1,444
Triangles
Prints flat as a plate, no supports.
Bike tyre lever
MAIN PURPOSE: Remove bike tyres from rims
A stiff tyre lever with a spoon tip that slides under the bead and a hooked tail that clips onto a spoke; print two or three in PETG or nylon for the saddle bag.
Printing notes
12.5 cm³
Volume
15.4 g
Est. weight
252
Triangles
Prints flat as a plate, no supports.
Bike multitool case
MAIN PURPOSE: Carry a bike multitool and levers
A fitted case for a folding bike multitool and two tyre levers, with a telescoping lid shown beside it.
Printing notes
175.9 cm³
Volume
218.1 g
Est. weight
5,728
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Bike puncture repair kit tin
MAIN PURPOSE: Carry bike puncture repair supplies
Three bays for patches, glue and sandpaper in a tin that fits a saddle bag, with PUNCTURE KIT on the telescoping lid.
Printing notes
44.7 cm³
Volume
55.4 g
Est. weight
8,516
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
