Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG for stiff columns. Needs stretch fabric and an LED puck. Prints as shown on its floor, no supports.
Print the dish as one piece; a darker colour shows the points best. Prints as shown on its outline, no supports.
Print open end up, then stand it on its open end. Print floor-down as shown, then turn it over to use it.
Print upright. Holds a portrait postcard (105 x 148). Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Print in dark blue or black so the lit stars stand out. Prints as shown on its floor, no supports.
PETG or PLA; use backflow cones only and never leave them burning unattended. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging. Stacked parts are fused into one print.
Print flat; glow-in-the-dark or translucent PETG suits it.
Print in terracotta or matte black; lid prints separately. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print lying flat; stand it on the baseline.
Print in ASA or PETG for the garden. Prints flat as a plate, no supports.