Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
The tube takes three rolled overgrips; dampeners go in the small bays. Prints as shown on its floor, no supports. The lid prints as a separate part, top down. The added base's lid prints separately.
Needles go in the screw-top tube so they never end up in a toe pad. Prints as shown on its floor, no supports. The added base's lid prints separately.
Cups fit boules up to 76 mm; the centre box holds the jack and a measuring tape. Prints as shown on its floor, no supports.
The cups take standard tape rolls; the box takes stick wax and a lace hook. Prints as shown on its floor, no supports.
The small screw-top keeps the needles; the tube takes pumps up to 32 mm. Prints as shown on its floor, no supports. The added base's lid prints separately.
Screw to the wall through the two keyholes; PETG for a garage. Prints as shown on its floor, no supports.
The cup takes handles up to 58 mm; feed the charger cable through the back slot. Prints as shown on its floor, no supports.
Print in PETG; the slots let the goggles drip dry in the bag. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG; wash in warm soapy water, not the dishwasher. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Holds six feather or nylon shuttles stacked nose-down. Prints as shown on its floor, no supports. The threaded lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.