Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print the lid in a speckled filament for a real egg look. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print in PETG; the slots let the goggles drip dry in the bag. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG; wash in warm soapy water, not the dishwasher. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Write the grain weights on the lid label strip. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Put a sponge soaked in 1:4 sugar water in some petals and orange slices in others; refresh every two days. Prints as shown on its floor, no supports.
Bird-safe use: print in natural PLA, check for loose strings each week and remove if chewed sharp. Prints as shown on its floor, no supports.
Thread a 40 mm belt through the two back slots; PETG for mud and rain. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Mount on a post or fence through the keyholes; ASA or PETG outdoors. Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
Put it between two seats; a half turn swaps the sides. Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Fits batons up to 290 mm with a 22 mm handle; print lying flat. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.