Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print flat in PETG, 2 mm; print six to ten.
Print as it comes (comb on the bed), solid; fix with foam tape.
Print several; 3 mm cord and a bead to clamp. Prints as shown on its floor, no supports.
Prints flat as a plate, no supports.
Print top down. Print it as shown, then turn it over so the floor becomes the top. Print floor-down as shown, then turn it over to use it.
Print top down. Print it as shown, then turn it over so the floor becomes the top. Print floor-down as shown, then turn it over to use it.
Print floor down; the floor becomes the back. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print flat; the peg prints upright, a touch of support under the cap. Stacked parts are fused into one print.
Print floor down. Prints as shown on its floor, no supports.
Print eight flat in PETG; twelve M4 bolts and nylock nuts. Prints flat as a plate, no supports.