Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Print in PETG for a little flex. Prints flat as a plate, no supports.
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Prints as shown on its floor, no supports.
The 22 mm bore is a press fit; sand it lightly if the bearing will not go in. Prints flat as a plate, no supports. Large holes in the walls may need supports or good bridging.
Check the 31 mm hole spacing against your motor before bolting up. Prints flat as a plate, no supports.
Print a handful. Print floor-down as shown, then turn it over to use it.
Prints flat as a plate, no supports. Large holes in the walls may need supports or good bridging.
Prints flat as a plate, no supports.
Prints flat as a plate, no supports.