Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Glue 16 x 6 x 3 mm magnets flush, polarity as described. Prints as shown on its floor, no supports.
Twelve 6 x 3 mm magnets. Prints as shown on its floor, no supports.
Print floor down; the floor becomes the back. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print 24 flat in PETG; 36 M3 screws and nylock nuts. Prints flat as a plate, no supports.
Print upright, 4 walls for a stiff stem. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Print twelve flat; two M3 bolts. LED lights only. Prints flat as a plate, no supports.
Print four flat in PETG; M4 bolts, nylock nuts, a pencil. Prints flat as a plate, no supports.
Print open side down; 8 mm and 6 mm dowels. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
PETG. Print flat.
Prints in one piece; the pens rest on the desk inside. Print floor-down as shown, then turn it over to use it.