Showcase
Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Split cereal bowl
MAIN PURPOSE: Eat cereal without it going soggy
Keeps cereal crunchy: cereal goes on one side and milk on the other, and you pour a little milk over with each spoonful.
Printing notes
164.3 cm³
Volume
203.8 g
Est. weight
852
Triangles
For food contact, print in a food-safe PETG and wash by hand. Prints as shown on its floor, no supports.
Ice lolly drip guard
MAIN PURPOSE: Catch ice lolly drips
Push the lolly stick through the slot so melting drips land in the saucer instead of on small hands and sleeves.
Printing notes
17.5 cm³
Volume
21.7 g
Est. weight
1,344
Triangles
Print two or three for the freezer. Prints as shown on its floor, no supports.
MAIN PURPOSE: Help beginners use chopsticks
Clip two chopsticks into the holes and the connector holds their tops together like tongs, so children and beginners can pinch food straight away.
Printing notes
1.0 cm³
Volume
1.3 g
Est. weight
1,346
Triangles
Print in PETG or TPU. Prints as shown on its floor, no supports.
MAIN PURPOSE: Cut star-shaped cookies
A star cookie cutter with a closed top you can press hard on; the thin walls cut cleanly and the two vent holes let the dough drop out. Print it as shown, then turn it over so the floor becomes the top.
Printing notes
8.3 cm³
Volume
10.3 g
Est. weight
452
Triangles
For food contact, print in a food-safe PETG and wash by hand. Print floor-down as shown, then turn it over to use it.
MAIN PURPOSE: Keep a walking stick within reach
Clamps to the edge of a table or a counter and holds a walking stick upright in the ring, so it doesn't slide to the floor at a café or the dinner table.
Printing notes
21.1 cm³
Volume
26.2 g
Est. weight
1,008
Triangles
Print lying flat in PETG.
Webbing tri-glide slider
MAIN PURPOSE: Repair adjustable bag straps
A replacement tri-glide for 25 mm bag and backpack straps: thread the webbing through both slots to make the strap adjustable again.
Printing notes
1.7 cm³
Volume
2.1 g
Est. weight
1,964
Triangles
Print in PETG or nylon. Prints flat as a plate, no supports.
Sand and snow tent peg
MAIN PURPOSE: Pitch a tent on sand or snow
A wide blade peg that holds in loose sand and snow where thin pegs pull out: bury it at an angle with the guy line hooked over the head.
Printing notes
20.5 cm³
Volume
25.4 g
Est. weight
1,364
Triangles
Print flat in PETG; print a set.
Planter bookend
MAIN PURPOSE: Support books while growing a plant
A heavy planter that also holds up a row of books: fill it with soil and a trailing plant, and its flat side stops the books leaning over.
Printing notes
58.5 cm³
Volume
72.6 g
Est. weight
1,340
Triangles
Prints as shown on its floor, no supports.