Showcase
Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Photo and postcard slot stand
MAIN PURPOSE: Display photos and postcards with pens
A long low stand with two thin slots that hold photos and postcards upright, and a trough behind for pens.
Printing notes
38.1 cm³
Volume
47.3 g
Est. weight
2,904
Triangles
Prints as shown on its floor, no supports.
Hot-desk caddy with carry handle
MAIN PURPOSE: Carry your desk kit between desks
Carry your desk kit from desk to desk: two bays either side of a tall middle wall with a hand hole.
Printing notes
109.9 cm³
Volume
136.3 g
Est. weight
1,668
Triangles
Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Power brick cradle for the desk leg
MAIN PURPOSE: Hang a power brick off the floor
An open-ended cradle for a laptop or monitor power brick that hangs on the desk leg, a back panel or the wall from two keyholes, keeping the brick and its cables off the floor.
Printing notes
19.3 cm³
Volume
24.0 g
Est. weight
1,532
Triangles
Prints as shown on its floor, no supports.
Hopper-front parts bin
MAIN PURPOSE: Store small parts with easy scoop access
A deep parts bin with a low front, a scooped inner front edge that funnels parts to your fingers, and a label slot.
Printing notes
52.2 cm³
Volume
64.8 g
Est. weight
1,234
Triangles
Prints as shown on its floor, no supports.