Showcase
Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Shadow box frame
MAIN PURPOSE: Display keepsakes behind glass
A deep display frame for keepsakes: the glass from a 6 x 8 inch photo frame slides into grooves along three sides from the low top edge, and it hangs from two nail holes.
Printing notes
97.1 cm³
Volume
120.4 g
Est. weight
508
Triangles
Prints as shown on its floor, no supports.
Enamel pin display board
MAIN PURPOSE: Display an enamel pin collection
A perforated board for enamel pin collections: push the pins through any of the holes and fit the backs behind; hangs on two nails through the holes.
Printing notes
103.9 cm³
Volume
128.8 g
Est. weight
19,612
Triangles
Prints flat as a plate, no supports.
Minifigure display case
MAIN PURPOSE: Display minifigures and small collectibles
Twelve cells for minifigures and small collectibles with a lift-off lid.
Printing notes
424.1 cm³
Volume
525.9 g
Est. weight
308
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Coin sorter
MAIN PURPOSE: Sort coins into four sections
A round coin box with four sections and a press-on lid.
Printing notes
64.6 cm³
Volume
80.1 g
Est. weight
1,600
Triangles
Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.