Showcase
Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
MAIN PURPOSE: Loosen a tight shirt collar under a tie
Button the shirt button through the slot and tilt the T toggle through the collar buttonhole: the collar gains 12 mm, so a shirt that has become tight round the neck closes comfortably under a tie.
Printing notes
0.9 cm³
Volume
1.2 g
Est. weight
860
Triangles
Print flat in PETG; white or clear hides best.
MAIN PURPOSE: Collect empty hangers in one tidy stack
Hook empty hangers over the 14 mm post as you take clothes out: up to thirty stack neatly on one spot beside the wardrobe instead of tangling on the rail, and the next laundry load finds them all together.
Printing notes
76.7 cm³
Volume
95.2 g
Est. weight
2,200
Triangles
Print with 4 walls so the post stays stiff. Prints as shown on its floor, no supports. Stacked parts are fused into one print.
Belt hole spacing template
MAIN PURPOSE: Punch evenly spaced holes in a belt
Lay a 35 mm belt between the two rails and mark through the holes with an awl: new holes come out on the centre line at the standard 25 mm pitch, so a punched belt looks factory-made instead of wandering.
Printing notes
18.9 cm³
Volume
23.4 g
Est. weight
4,852
Triangles
Prints as shown on its floor, no supports.
MAIN PURPOSE: Add a hook to any door without screws
Hangs a dressing gown, a towel or tomorrow's outfit on any door up to 40 mm thick, with no screws: the top hooks over the door and the hook sits low on the back.
Printing notes
29.8 cm³
Volume
37.0 g
Est. weight
552
Triangles
Print lying flat so the layers run along the hook.
MAIN PURPOSE: Hang clothes vertically to save rail space
Doubles wardrobe rail space: hook it over one hanger's neck and hang the next hanger from the eye below, so several outfits hang one under another.
Printing notes
9.2 cm³
Volume
11.4 g
Est. weight
664
Triangles
Print flat in PETG; print one per extra hanger.
Pocket shoe horn
MAIN PURPOSE: Put shoes on without crushing the heel
A short curved shoe horn for a coat pocket or a gym bag: slide it in behind the heel and step in without crushing the back of the shoe.
Printing notes
42.6 cm³
Volume
52.8 g
Est. weight
632
Triangles
Print as it comes, curved outline on the bed.
Shoe space saver
MAIN PURPOSE: Store pairs of shoes in half the space
Halves the shelf space a pair of shoes takes: one shoe sits on the top deck and its partner slides underneath, heel to the open side.
Printing notes
241.6 cm³
Volume
299.6 g
Est. weight
392
Triangles
Print as it comes (side outline on the bed), then lay it down.
Hat and cap wall pegs
MAIN PURPOSE: Hang hats and caps on the wall
Screw the plate up by the door and hang caps and hats on the four rounded pegs, so they keep their shape instead of being squashed on a hook. Print it lying flat.
Printing notes
156.0 cm³
Volume
193.5 g
Est. weight
3,708
Triangles
Prints flat as a plate, no supports.