Showcase
Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Spinning screw carousel
MAIN PURPOSE: Spin screws into reach by size
A round eight-section screw tray that spins on BBs, so every size is a turn away.
Printing notes
507.6 cm³
Volume
629.5 g
Est. weight
6,168
Triangles
Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Workshop scrap bin
MAIN PURPOSE: Collect offcuts and shavings at the bench
A tall bench-side bin with an open dome top for offcuts and shavings, with SCRAP on the back.
Printing notes
282.8 cm³
Volume
350.7 g
Est. weight
4,556
Triangles
Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
Twist-lock rivet tub
MAIN PURPOSE: Store rivets without spilling
A round tub with a twist-lock lid that will not spill rivets if it tips over.
Printing notes
84.7 cm³
Volume
105.1 g
Est. weight
1,968
Triangles
Prints as shown on its floor, no supports. The twist-lock lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.
