Showcase
Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Jewellery box with two drawers
MAIN PURPOSE: Store rings and earrings in drawers
Two ring-pull drawers for rings and earrings with rounded corners.
Printing notes
261.6 cm³
Volume
324.4 g
Est. weight
1,444
Triangles
Prints as shown on its floor, no supports. The 2 drawers print separately from the case.
Three-tier jewellery tower
MAIN PURPOSE: Stack three tiers of jewellery cells
Three stacking nine-cell jewellery tiers with a lid on top.
Printing notes
230.8 cm³
Volume
286.2 g
Est. weight
576
Triangles
Prints as shown on its floor, no supports. The added base's lid prints separately. Stacked parts are fused into one print.
Diamond pattern jewellery chest
MAIN PURPOSE: Store jewellery in six patterned cells
A six-cell jewellery chest wrapped in a raised diamond pattern with a telescoping lid.
Printing notes
248.8 cm³
Volume
308.5 g
Est. weight
7,100
Triangles
Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Rotating jewellery carousel
MAIN PURPOSE: Display jewellery on a spinning carousel
An eight-section jewellery carousel that spins on BBs.
Printing notes
409.3 cm³
Volume
507.6 g
Est. weight
6,168
Triangles
Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.