Showcase
Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Gridfinity 2x2 kit with baseplate
MAIN PURPOSE: Start a drawer with a Gridfinity kit
A 2x2 Gridfinity bin with four pockets and a matching 2x2 baseplate to start a drawer.
Printing notes
55.4 cm³
Volume
68.7 g
Est. weight
3,672
Triangles
Prints as shown on its floor, no supports. The Gridfinity baseplate prints separately.
Spinning screw carousel
MAIN PURPOSE: Spin screws into reach by size
A round eight-section screw tray that spins on BBs, so every size is a turn away.
Printing notes
507.6 cm³
Volume
629.5 g
Est. weight
6,168
Triangles
Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Rotating brush caddy
MAIN PURPOSE: Spin paint brushes into reach
A hexagon paint brush caddy in six sections on a Lazy Susan base.
Printing notes
342.2 cm³
Volume
424.3 g
Est. weight
5,168
Triangles
Prints as shown on its floor, no supports. The turntable ring prints separately and runs on 6 mm BBs.
Workshop scrap bin
MAIN PURPOSE: Collect offcuts and shavings at the bench
A tall bench-side bin with an open dome top for offcuts and shavings, with SCRAP on the back.
Printing notes
282.8 cm³
Volume
350.7 g
Est. weight
4,556
Triangles
Prints as shown on its floor, no supports. Print the hood upside down, roof on the plate.
