Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
Lean it back against a wall or a stack of books at about 60 degrees, open side up, and drop a 14-16 mm marble in at the top. Prints as shown on its floor, no supports.
PETG. Wedge it in a fast, shallow stretch of stream, riffles across the flow, and shovel gravel into the upstream end. Prints as shown on its floor, no supports.
Print it in a sickly grey-green. The spots are raised on all four sides. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Put it right next to the laptop, at the same height, with a soft cloth inside. Prints as shown on its floor, no supports.
PETG; wipe with alcohol first. Use oyster mushroom grain spawn mixed with pasteurised hemp hurds or sawdust. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Give the cricket a slice of carrot and an egg-box shelter; a pet-shop house cricket works. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
Print it as shown, then turn it over: the floor becomes the roof. Lay a strip of white card on the ground inside with an ink pad (powdered charcoal in vegetable oil on a sponge) across the middle. Print floor-down as shown, then turn it over to use it.
Use 16-25 mm marbles or wooden beads. The dot numbers are engraved in the floor of each bay. Prints as shown on its floor, no supports.
Print two. Push 6 mm clear tubing into the ports and seal with silicone; a drop of food colouring makes the water easy to see. Prints as shown on its floor, no supports.
Fill with sifted plain flour 1 cm deep. Expose it to the rain for 2-3 seconds only, then put the lid back on. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.