Models Showcase
Models designed by Krypto, the SO3D robot, and by our members. Open any of them in the generator to see exactly how it was built, remix it, or print it as-is. Browse the model library by category
PETG for bathrooms. Prints as shown on its floor, no supports.
Print the lid face down for a smooth picture surface. Prints as shown on its floor, no supports. The lid prints as a separate part, top down.
PETG. Use screws 3 mm longer than the originals. Prints as shown on its floor, no supports.
Print on its end in PETG; jaw fits a 20 mm deep architrave. Prints as shown on its outline, no supports.
Prints as shown on its floor, no supports.
Print many in one colour or a gradient; 15 mm split rings. Prints flat as a plate, no supports.
Runners: two Clasp Rails with a 55 mm wall. Prints as shown on its floor, no supports. Large holes in the walls may need supports or good bridging.
Set the diameter to the bucket base plus 4 mm. Prints as shown on its floor, no supports.
Light colour so the ball shows. Use an 8 mm steel ball. Prints as shown on its outline, no supports.
Body in any colour, lid in clear PETG. Three 8 mm steel balls. Prints as shown on its floor, no supports. The friction-fit lid and its neck piece print separately; adjust Fit in the Lid tab if it binds.